| Aura panel | ||||
|---|---|---|---|---|
| ||||
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
The following basic data settings are necessary to be able to use this interface. |
Contents
| Table of Contents |
|---|
Function in the order
ADMIN → EDI → EDI PARTNER
EcoTransIT - recipient of our data - is recorded as an EDI partner (ETW).
If data is to be transmitted manually via the XML-to-partner function, an additional EDI partner (CO2) is required for this.
The EDI partners are automatically supplied by CargoSoft when the interface is set up.
ADDRESSES → ADDRESSES → General tab → Classification sub tab
If the CO2 emission calculation is to be triggered by defined addresses in the order, the value CO2 is stored as classification.
ADMIN → EDI → EDI code conversions
The standard EDI code conversions are automatically delivered by CargoSoft when the interface is set up (transport mode truck, rail, barge).
If other terms are used for these modes of transport, e.g. BiSchi for barge, this term must be translated in the EDI code conversion for the interface.
The entry shall be made as follows:
Field | Entry |
|---|---|
EDI partner | ETW |
Direction | send |
Table | MOT |
Source code | The term to be translated |
Destination code |
|
ORDER → TYPE OF TRANSPORT
In this master data function, the modes of transport are entered that are available for selection in the mode of transport field on the Transport tab in the order.
ADMIN → STATUS TYPES → STATUS EVENTS
The status events are automatically delivered by CargoSoft when the interface is set up.
Automatic email notification
If an automatic e-mail notification is to be generated when a status message is received from EcoTransIT, the e-mail address must be stored in the field Mailing list for info for the provider ECOTRANSIT for the desired status code.
ADMIN → STATUS TYPES → STATUS TYPES
Set status in the order
In order for a corresponding status to be displayed in the order, a status type must be entered and then selected accordingly in status events.
In the status events, the status type CO2 for the provider ECOTRANSIT is entered in the field Status type.
ADMIN → CS ADMIN → CS CODES EXT
The relevant CS Codes Ext entries are automatically supplied by CargoSoft when the interface is set up.
Global settings
ATTENTION: Global_sett_t entries are made by CargoSoft!
CO2_CALCULATION | General activation of the emission calculation (always necessary). |
|---|---|
CO2_CALCULATION_ALL_SHIPMENTS | Emission calculation only for files with classified address. |
CO2_CHECK_ETD | Emission calculation is only carried out when the ETD date has been recorded in the file. |
CO2_CHECK_ATD | Emission calculation is only carried out when the ATD date has been recorded in the file. |