Set up CEP service provider

Owned by Hauke Gulich
Last updated: Mar 13, 2024 by Bärbel Neitzel
3 min read

Contents

ADMIN → EDI → EDI PARTNER

Enter EDI partner SENDIT

The transmission to service providers requires the EDI partner SENDIT.

Enter SENDIT as description.

  • In the addresses of the CEP service providers, this EDI partner is the Reference field → see below under sub-tab EDI references.

image-20240313-102513.png

ADMIN → CS ADMIN → CS CODES EXT

Create service provider codes

On the Services tab → Overview tab, all CEP service providers used should be made available for selection in the Transport type field.

image-20240313-102627.png

When selecting the CEP service provider, the service provider address should automatically be pre-assigned.

The EDI partner [SENDIT] is stored in the service provider address.

The EDI partner is used by the interface.

The service provider codes for the selection in the field Mode of transport are recorded as follows:

Field

Content

Field

Content

Type

TPTPART

Qualifier

K

Since the codes assigned here are used for additional filter functions, the following codes must be assigned:

  • DHL         = DHL

  • Hellmann = HEL

  • FedEx       = FED

  • UPS         = UPS

  • TNT         = TNT

ADDRESSES → Address tab

Record CEP service provider as address 

Please enter the address of the service provider in the address basic data.

  • If you work with classifications, these can be marked as CEP service providers on the General tab → Classifications sub-tab.

ADDRESSES → Address tab → EDI References sub tab

Qualify CEP service provider as EDI partner

All addresses that are CEP service providers must be marked in the address.

Enter the Reference SENDIT and the qualifier [TPKPF] in the sub-tab EDI references in ADDRESSES, so that the EDI partner is automatically preset when this address is used.

COMPANY → SERVICES

Pre-assign service providers address

The preallocation of the service provider address can be configured in basic data COMPANY → SERVICES.

The service provider should be pre-assigned automatically on the Services tab once you select the service type [KEP] and a mode of transport (e.g. DHL).

This setting is made per

  • mode (AIR, SEA…) 

  • sector (E, I..), and

  • mode of transport (KEP).